Extending Or Retracting The Retractable Lifting Handles; Securing The Patient With The Restraint Straps - Stryker M-1 Manual Del Usuario

Extending or retracting the retractable lifting handles

Note: Always make sure that you lock the retractable lifting handles before you lift the product.
To extend or retract the retractable lifting handles
1. Press the release buttons to pull out or push in the retractable lifting handles.
2. Release the release buttons when the handles lock into the intermediate position.
3. Press the release buttons to pull out or push in the retractable lifting handles again.
4. Release the release buttons when the handles lock into the fully extended or retracted position.
A

Securing the patient with the restraint straps

WARNING
• Always use all restraint straps to secure the patient on the cot. An unrestrained patient may fall from the cot.
• Do not attach restraint straps to the base tubes or cross tubes.
CAUTION
Do not entangle the restraint straps in the base frame when you raise or lower the cot.
Secure restraint straps to the cot in the required attachment locations
page 1-24). Restraint strap attachment locations should provide strong anchorage and proper restraint position. Do not
allow restraint straps to interfere with equipment or accessories. Buckle the restraint straps across the patient's
shoulders, waist, and legs. Buckle restraint straps when the cot is not in use.
To install the restraints:
1. Wrap the restraint strap around the cot frame.
2. Push the restraint strap buckle through the loop.
3. Pull the buckle around the loop to secure the restraint strap to the cot.
www.stryker.com
Operation
(Figure 1-10 on page
Figure 1-10: Extending and retracting the lifting handles
6100-109-005 REV B
1-23):
A
(Figure 1-11 on page 1-24 and
English
EN
Figure 1-12 on
1-23