Regular Cleaning - STAMOS S-LS-3 Manual De Instrucciones

1. Before heater replacement make sure that the SMD rework gun is completely cold.
2. Remove the screws in the gun covers.
3. Unscrew the element of the handle (2) and take off the gun covers.
4. Gently remove the fan and remove the wire board screws.
5. Disconnect the heater from the wire board (pay attention to the wires connection order).
6. Remove the heater from the housing, pay attention to the steel grounding wire.
7. New heater should be wrapped with new mica paper and then it should be placed inside the housing.
8. Connect the wires to the board in accordance with their original connection method.
9. Fix the gun in reverse order.

REGULAR CLEANING

Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brushes or any other type of cleaning
utensil that could damage the surface of the appliance.
• Before cleaning you must remove the electricity supply plug isolating the appliance from the main power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case, please contact your customer service
to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latest is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determinate the source of the problem if you make a detailed and
precise description of the matter. Avoid formulations like "the device doesn´t heat", which may mean that it doesn´t
heat enough or even not at all. Though, those two possibilities have a different causation!
The more detailed your information, the quicker the customer service will be able to answer your problem rapidly and
efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a loss of warranty!
EN DE
11