Advanced Operations; Programming Signals Of Another Remote Control - Sony RM-VL1400T Manual De Instrucciones

Advanced Operations

Programming Signals of
Another Remote Control
—Learning function
To operate non-preset A/V components or button
functions, use the following "learning" procedure to
"programme" any of the programmable signals on the
Remote Commander's buttons.
You can also use the Learning function to change the
signal of individual buttons after setting the preset code
(page 7). You may find it useful to change the label (page
15) of the learned button.
Note
Some specific remote control signals may not be learned.
1
Place the Remote Commander head to
head with your A/V component's remote
control.
Other remote control
about 2-4 inches
(5-10 cm) away
2
While pressing the
the OTHER button.
"SET MODE" appears as the screen title.
3
Press the V/v buttons to select "2
LEARN", then press the OK button or the
centre Label select button.
"LEARN" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
GB
12
RM-VL1400T
(light) button, press
4
Press the COMPONENT select button or
Label select button corresponding to the
A/V component you want the Remote
Commander to learn.
The selected A/V component's label appears in the
second line on the screen.
5
Press the button on which you want to
programme the signal.
The display turns off and the Remote Commander
enters into the learning mode.
Tip
If you press and hold the button for over 2 seconds, you can
change the label. For details, see "Changing the characters
on the screen" (page 15).
6
Press and hold the button on the other
remote control until you hear a beep.
A beep sounds and the learned button name and
"OK" appear in the third line on the screen.
7
To programme signals on other buttons,
repeat steps 5 and 6.
8
Press the (light) button.
The display returns to the screen shown in step 3.