Programming A Signal On The Component Select Button - Sony RM-VL1400T Manual De Instrucciones

9
Press the (light) button or the RETURN
button twice.
The set mode closes, and the Remote Commander
returns to standby for operating the A/V components.
Notes
• If you do not input anything into the Remote Commander
within 60 seconds between each step, the setup procedure will
be cancelled and the set mode closes. Start over from the
beginning.
• If you do not perform step 6 within 10 seconds after
performing step 5, a beep sounds twice and the selected button
name and "NG" appear in the third line on the screen, then the
display returns to the screen shown in step 4. Start over from
step 5.
• If the Remote Commander learns signals incorrectly in step 6,
clear the learned signal by pressing the
pressing the button on which the incorrect signal was learned
(page 14). Start over from step 5.
• If you programme remote signals on the TV or amplifier's
volume control buttons using the Learning function (page 12),
those buttons will also send the learned signal to control
components other than a TV or amplifier.
If you programme remote signals on the volume control
buttons of components other than a TV or amplifier, those
buttons will also send the learned signal to control other A/V
components instead of controlling the TV or amplifier's
volume.
• To avoid misoperation, the Remote Commander will only
transmit z/REC (record) button signals if the button is pressed
and held for over 2 seconds. Therefore, if this button is used for
a learned operation, you must press and hold it for over 2
seconds.
Programming a signal on the
COMPONENT select button
1
2
3
(light) button while
4
5
6
Perform steps 1-3 of the learning
procedure (page 12).
Press and hold the COMPONENT select
button or Label select button on which you
want to programme the signal.
The display turns off and the Remote Commander
enters into the Learning mode.
Press and hold the button on the other
remote control until you hear a beep.
A beep sounds and the learned button name and
"OK" appear in the third line on the screen.
To programme signals on other
COMPONENT select buttons or Label
select button, repeat steps 2 and 3.
Press the (light) button.
"LEARN" appears as the screen title.
Press the (light) button or the RETURN
button twice.
The set mode closes, and the Remote Commander
returns to standby for operating the A/V components.
GB
13
Continued