Sony RM-VL1400T Manual De Instrucciones página 32

Problem
You cannot operate a component
even after you programmed the
remote control signals with the
"learning" function.
"NG" appears in the third line
on the screen and a beep
sounds five times while setting
the preset code.
"NG" appears in the third line
on the screen and a beep sounds
five times while learning.
"FULL" appears in the third
line on the screen and a beep
sounds five times while
learning.
"NG" appears in the third line
on the screen and a beep sounds
five times when trying to copy
settings of a component label to
another component label.
A beep sounds twice while
setting the preset code.
A beep sounds twice while
learning.
A beep sounds twice while
programming a Component
Macro.
"NG" appears in the third line
on the screen and a beep sounds
twice while programming the
power-on function.
32 GB
Solution
Make sure that the Remote Commander has learned the correct signals. If not, see
"Notes" on page 13 or "For accurate learning" (page 14), and try the learning procedure
again (page 12).
Preset code setting has not succeeded. Set the preset code again, referring to the
supplied "Preset Code List".
• Learning has not succeeded. Try the learning procedure again (page 12), referring to
"For accurate learning" (page 14).
• While learning, you pressed the button other than the one on which you want to
programme the signal. Programme the signal on the correct button again (page 12).
Learned signal memory is full. Clear learned signals that are not frequently used (page
14), then programme the desired remote signal.
• Setting cannot be copied on COMPONENT select buttons or Label select buttons in
the following situations:
– A learned signal or Component Macro is programmed.
– The button's component label has been changed.
– The button's function label has been changed.
In this case, reset those settings (page 28) before copying.
• You are copying the settings of A/V components other than a TV or amplifier on the
Label select button assigned with a TV or amplifier. The TV button is assigned with
only TV and the Label select button to which an amplifier is preset is assigned with
only amplifier or DVD player home theatre system.
• The Remote Commander fails to copy the settings if the programmed signal data of the
button is too large. In this case, clear programmed signals that are not frequently used
(page 14), then copy the settings again.
The preset code cannot be set on the COMPONENT select button or Label select button
in the following situations:
– A learned signal or Component Macro is programmed.
– The button's component label has been changed.
– The button's function label has been changed.
In this case, reset those settings (page 28) before setting.
• See "For accurate learning" (page 14).
• Other remote signal has been programmed on the desired button. Clear the learned
signal (page 14) or programme the remote signal on another button (page 12).
• Learning standby time (10 seconds) has been exceeded. Start over from the beginning.
• You are assigning a Component Macro on the COMPONENT select button or Label
select button on which another Component Macro has been assigned. Clear the
Component Macro assigned to the button (page 20), then assign the desired
Component Macro.
• The programmed steps exceed 32 after adding delay while checking the Component
Macro. A maximum of 32 steps (including delay) can be programmed. Reprogramme
the Component Macro.
You are programming the power-on function (page 21) on the COMPONENT select
button or Label select button assigned with a preset code other than Sony's. The power-
on function can be programmed only on the button assigned with Sony's preset code.