Others; Setting The Button Illumination - Sony RM-VL1400T Manual De Instrucciones

Others

Setting the button
illumination
You can change the setting of the button illumination of
the Remote Commander. The button illumination is
preset at the factory to turn off automatically if you do
not operate within 10 seconds. You can also change the
brightness and fade effect (which adjusts the brightness
of the button illumination) of the button illumination and
which buttons activate the button illumination.
1
While pressing the
the OTHER button.
"SET MODE" appears as the screen title.
2
Press the V/v buttons to select "5 UNIT
SETTINGS", then press the OK button or
the centre Label select button.
"UNIT SETTINGS" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
3
Press the V/v buttons to select "1 LIGHT
OFF TIME", then press the OK button or
the centre Label select button.
"LIGHT OFF TIME" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
GB
24
(light) button, press
4
Press the B/b buttons or the left or right
Label select button.
You can set the automatic-off time from 1 to 60
seconds. Each time the button is pressed, the time
decreases/increases by 1 second.
Note
If you set the automatic-off time to longer than 10
seconds, the battery life may be shorter.
5
Press the (light) button, the centre
Label select button, the OK button, or the
RETURN button.
"UNIT SETTINGS" appears as the screen title.
6
Press the V/v buttons to select "2 LIGHT
BRIGHTNESS", then press the OK button
or the centre Label select button.
"LIGHT BRIGHTNESS" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
7
Press the B/b buttons or the left or right
Label select button.
You can set the brightness from 1 to 15. Each time
the button is pressed, the level decreases/increases by
1.
8
Press the (light) button, the centre
Label select button, the OK button, or the
RETURN button.
"UNIT SETTINGS" appears as the screen title.