Setting A/V Components Which Are Not Listed In The Preset Code List - Sony RM-VL1400T Manual De Instrucciones

5
Press the number buttons to enter the four-
digit preset code, then press the OK button
or the centre Label select button.
Example: To enter "8095"
Press 8, 0, 9, 5 then the OK button.
A beep sounds, and the four-digit preset code you
have set and "OK" appear on the screen, then the
display returns to the screen shown in step 3.
6
To set preset codes for other A/V
components, repeat steps 4 and 5.
7
Press the (light) button or the RETURN
button twice.
The set mode closes, and the Remote Commander
returns to standby for operating the A/V components.
Notes
• If you enter a preset code that is not on the table in the supplied
"Preset Code List" and press the OK button, a beep sounds five
times, and the entered four-digit number and "NG" appear on
the screen, then the display returns to the screen shown in step
4. Check the preset code, and try entering the code again.
• If you do not enter anything into the Remote Commander
within 60 seconds between each step, the setup procedure will
be cancelled and the set mode closes. Start over from the
beginning.
• The Remote Commander recognizes the A/V component type
when a preset code is entered in step 5, and the screen title
displayed when operating the A/V component is determined. If
the screen title does not correspond with the component you
have set, you can change the component label accordingly.
• You cannot set A/V components after you programme other
remote control signals using the Learning function (page 12),
programme a Component Macro (page 18), or change the label
(page 15). In such a case, reset the A/V component settings
(page 28), then set the A/V components again.
8 GB
Setting A/V components which are
not listed in the Preset Code List
—Search function
You can set A/V components which are not listed in the
supplied "Preset Code List" using the search function.
Before starting the search function
Set each A/V component to the following status so that
the search function works effectively.
TV, AMP: Power-on
CD player, MD deck, Casssette deck: Power-on with
a playback source.
Other component: Power-off
1
While pressing the
the OTHER button .
"SET MODE" appears as the screen title.
2
Press the V/v buttons to select
"1 PRESET", then press the OK button or
the centre Label select button.
"PRESET" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
3
Press the COMPONENT select button for
the desired A/V component.
The selected A/V component's label and the preset
code currently set appear on the screen.
(light) button, press