Controlling The Volume Of Visual Components Connected To An Audio Component - Sony RM-VL1400T Manual De Instrucciones

Controlling the volume of
visual components connected
to an audio component
The volume control buttons (2 +/- and %) of the
Remote Commander are factory preset to control the
volume based on the assumption that you hear the sound
of your visual components from your TV speakers, and
that you hear sound of your audio components from the
loudspeakers connected to your amplifier.
The remote control signal transmitted by pressing the
volume control buttons are factory preset as follows:
Visual component: Transmits the signal to control the
volume of a TV.
Audio component: Transmits the signal to control the
volume of an amplifier.
For example, to control the volume while using a DVD
player, you do not need to select the TV to control the
TV volume.
If an amplifier is connected to visual components,
change the volume control setting of all the visual
components to control the volume of the amplifier.
1
While pressing the
the OTHER button .
"SET MODE" appears as the screen title.
2
Press the V/v buttons to select
"6 UTILITY", then press the OK button or
the centre Label select button.
"UTILITY" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
(light) button, press
3
Press the V/v buttons to select "3 AUDIO
SETTING", then press the OK button or
centre Label select button.
"AUDIO SETTING" appears as the screen title.
Tip
If a number is displayed before the menu, you can select the
menu by pressing the number button.
4
Press the b button or right Label select
button.
A beep sounds and "AMP" is shown inside the [ ].
5
Press the (light) button or the RETURN
button three times.
The set mode closes, and the Remote Commander
returns to standby for operating the A/V components.
To reset the settings
Press the B button or the left Label select button in step 4.
23 GB