Assembly Preparation; Assembly Instructions; Mounting The Support Legs To The Cabinet Base - Pit Boss PBV3G1 Montaje Y Operación

Parts are located throughout the shipping carton, including underneath the smoker. Inspect the smoker, parts, and hardware
blister pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the
smoker before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not
attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Care for parts.
service@pitboss-grills.com | USA: (480) 923-9630 | CANADA (TOLL FREE): 1-877-942-2246
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed, or unless otherwise mentioned.
1. MOUNTING THE SUPPORT LEGS TO CABINET BASE
Parts Required:
1 x Cabinet Base (#21)
1 x Left Support Leg / Front (#22)
1 x Left Support Leg / Back (#23)
1 x Right Support Leg / Front (#24)
1 x Right Support Leg / Back (#25)
12 x Screw (#B)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly.
• Next, lay the cabinet base on the floor, upside down. Prepare the four
support legs for installation to the cabinet base, arranging the labeled
legs as shown in the illustration.
IMPORTANT: The four support legs must be arranged correctly to
properly install the support panels and support bar in later steps.
• Mount one support leg to the cabinet base using three screws. Repeat
installation for the other three support legs. Tighten inside screws
completely, but leave outside screws partly loosened.

ASSEMBLY PREPARATION

Parts are located throughout the shipping carton, including inside the
parts, and hardware blister pack after removing from the protective shipping carton. Before assembly
of product, review all parts and reference the parts list. If any part is missing or damaged, do not
attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
Customer Service for parts.
IMPORTANT: To ease installation, must using two people is helpful when assembling this unit.

ASSEMBLY INSTRUCTIONS

Tools required for assembly: screwdriver and wrench. Tools is not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not
tighten screws completely until all screws for that step have been installed, or unless otherwise
mentioned.
1.
Parts Required:
Installation:
Place a piece of cardboard on the floor to
prevent scratching the unit. Remove the Door
Assembly (#10) and set aside. Lay the Lower
Smoker Cabinet with Control Panel Assembly on
upside-down on the cardboard as Fig.1 shown.
Mount Right Front Leg (#22),Left Front Leg
(#21), Right Rear Leg with Wheel Assembly
(#18) and Left Rear Leg with Wheel Assembly
(#20) to the Lower Smoker Cabinet with Control
Panel Assembly (#14) using 12 x1/4-20*1/2"
Screws (#B)as Fig.1 & Fig.1.1 shown, tighten
inside screws only, but do not tighten all outside
screws yet as Fig.1 shown.
smoker. Inspect the unit,
1
22
23
21
6
24
25
7