Use Of The Tool; Starting The Tool; Stopping The Tool; Troubleshooting - CAMPAGNOLA ALICE Manual De Uso Y Mantenimiento

5

- uSe of the tool

5.1 Starting the tool

Before starting work, wear adequate clothing (see picture G) and check that all the safety devices are well assembled and can
operate properly.
WARNING!
• Start the tool only when it is among the branches. Any improper use damages the tool and causes excessive bat-
tery power consumption.
• Use the tool only for the aims described in chapter "Product description". Any other use may cause injuries.
• All information are in the use and maintenance manual of the chosen power unit.

5.2 Stopping the tool

The tool must always be switched off at the end of the work session:
• All information are in the use and maintenance manual of the chosen power unit.

5.3 Troubleshooting

WARNING!
All special maintenance operations shall be carried out only by well-trained personnel.
faultS
Mechanical head (2) overheating.
Anomalous rake (1) vibrations.
The tool does not work.
The tool is not powerful enough.
Temporary tool stopping during the use.
cauSe
• Dirt and/or wear and tear of the inner
rotating parts.
• Wear and tear of the rotating parts.
• Wrong tightening of the rake fixing
screws.
• Flat battery.
• Flat battery.
• Motor overheating due to thick trees.
• Exceeded current limits.
remedY
• Carry out the mechanical head (fig.C)
cleaning and maintenance operations.
• Carry out the mechanical head (fig.C)
cleaning and maintenance operations.
• Screw tightening.
• Re-charge the battery (see the power
unit manual).
• Re-charge the battery (see the power
unit manual).
• Get out of the tree, wait for few sec-
onds and then start the tool again by
means of the ON/OFF switch (see
the power unit manual).
21 - 68 61 - 68
21 - 96