Service And Repairs - Metabo HPT C 3607DRA Manual De Instrucciones

9. Lubrication
Lubricate the following sliding surfaces once a month
to keep the power tool in good operating condition for
a long time (see Fig. 2 and Fig. 3). Use of machine oil
is recommended.
Oil supply points:
○ Rotary portion of hinge
○ Rotary portion of vise assembly
○ Rotary portion of holder (A)
10. Cleaning
Duct
Air gun
Clean the machine, duct and lower guard by blowing
with dry air from an air gun or other tool. (Fig. 59)
Periodically remove chips, dust and other waste
material from the surface of the power tool, especially
from the inside of the lower guard with a damp, soapy
cloth. To avoid a malfunction of the motor, protect it
from contact with oil or water.
If the laser line becomes invisible due to chips and
the like adhered onto the window of the laser marker's
light-emitting section, wipe and clean the window with
a dry cloth or a soft cloth moistened with soapy water,
etc.
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).
Lower guard
Fig. 59

SERVICE AND REPAIRS

All quality power tools will eventually require servicing or
replacement of parts because of wear from normal use. To
assure that only authorized replacement parts will be used
and that the double insulation system will be protected,
all service (other than routine maintenance) must be
performed by an AUTHORIZED metabo HPT POWER
TOOL REPAIR CENTER ONLY.
NOTE
Specifi cations are subject to change without any
obligation on the part of metabo HPT.
English
41