Service And Repairs - Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones

English
6. Storage
After operation of the tool has been completed, check that the following has been performed:
(1) Trigger switch is in OFF position,
(2) Power plug has been removed from the receptacle,
When the tool is not in use, keep it stored in a dry place out of the reach of children.
7. Lubrication
Lubricate the following sliding surfaces once a month to keep the power tool in good operating condition for a
long time (see Fig. 1 and Fig. 2). Use of machine oil is recommended.
Oil supply points:
* Rotary portion of hinge
* Rotary portion of vise assembly
* Rotary portion of holder (A)
8. Cleaning
Duct
Air gun

SERVICE AND REPAIRS

All quality power tools will eventually require servicing or replacement of parts because of wear from normal use. To
assure that only authorized replacement parts will be used and that the double insulation system will be protected,
all service (other than routine maintenance) must be performed by an AUTHORIZED metabo HPT POWER TOOL
REPAIR CENTER ONLY.
NOTE:
Specifi cations are subject to change without any obligation on the part of metabo HPT.
26
Lower Guard
Fig. 51
Clean the machine, duct and lower guard by blowing with dry
air from an air gun or other tool.
Periodically remove chips, dust and other waste material from
the surface of the power tool, especially from the inside of the
lower guard with a damp, soapy cloth. To avoid a malfunction
of the motor, protect it from contact with oil or water.
If the laser line becomes invisible due to chips and the like
adhered onto the window of the laser marker's light-emitting
section, wipe and clean the window with a dry cloth or a soft
cloth moistened with soapy water, etc.