TEFAL ClipsoMinut' Perfect Manual Del Usuario página 24

Troubleshooting
Problems
If you are unable
to close the lid:
If your pressure
cooker has been
heated under
pressure without
liquid inside:
If the pressure
indicator emits a
clicking noise and
steam.
If the pressure
indicator has not
risen and nothing
is escaping
through the vent
during cooking:
If the pressure
indicator has risen
but nothing is
escaping through
the vent during
cooking:
All manuals and user guides at all-guides.com
Recommendations
Check that the lid handle is in a vertical position.
Check that the gasket is positioned correctly (see
section "Cleaning and maintenance").
Check that the lid is positioned as indicated on
- Fig 1
.
Rinse the gasket under water and replace it in the lid
without drying it
insert it under each of the grooves on the lid.
Have your pressure cooker checked by a TEFAL Appro-
ved Service Centre.
This is normal during the first few minutes : it allows
escape of air before cooking.
This is normal during the first few minutes.
If the phenomenon persists, check that:
- The heat source is sufficiently strong; if not, increase
it.
- The quantity of liquid in the pot is sufficient.
- The operating valve (A) is positioned on
- Your pressure cooker is properly closed.
- There is no deterioration of the gasket or edge of the
pot.
- The gasket is correctly positioned.
This is normal during the first few minutes.
If the problem continues, put your pressure cooker
under cold tap water until the pressure indicator (D)
goes down.
Clean the operating valve (A)
release outlet - Fig. 17
that the security valve ball can be pressed without any
- Fig. 18.
problems
- fig 19 and 15 and take care to
- Fig. 16
and use a cotton bud to check
.
and the steam
19
EN