Symbol Definitions - Stryker Flyte Manual Del Usuario

0408-600-705 Rev-AB
Features
C
F
G
H
A Front Flexible Air Duct – This vent channels air to the front of the
helmet.
Height Adjustment Strap – This strap is adjusted to provide a
B
comfortable fit. Pull to extend or push to retract the length of the strap for
fit and comfort.
C Headlight Adjustment Handle – Available on the fiber-optic and battery-
powered headlight helmet models only. The handle is used to direct the
headlight beam.
D Hook – This hook aids in positioning the hood or toga lens on the helmet.
E Headlight – Available on the fiber-optic and battery-powered headlight
helmet models only.
F Light Shroud – Available on the fiber-optic and battery-powered headlight
helmet models only. The shroud prevents glare from the shield and may
be trimmed or removed as desired.
Microphone Indicator Light – Illuminates green while the microphone is
G
on.
H Power Loss Indicator Light – Flashes on and off red when the power
pack has a reduced amount of power remaining.
I Variable Control Buttons – Press these buttons to select a fan speed
level. There are six speed levels available. For helmets with a battery-
powered headlight, press both buttons simultaneously until the light turns
on or off, as desired.
J Microphone – A built-in microphone provides voice transmission to
compatible devices such as a dictation recorder.
K Microphone Button – Press this button to toggle the microphone on and
off (mute).
Attachment Points (two magnets) – These magnets secure the
L
disposable hood or toga lens to the helmet.
M Comfort Pads – These removable pads provide a comfortable fit.
www.stryker.com
A
B
D
E
J
K
I
M
O
N
L
V
N Adjustable Air Nozzle Tip – This vent channels air to the user's back.
Rotate the vent to direct flow toward or away from the neck for comfort.
O Headband Adjustment Knob – Customize the fit by turning the knob
clockwise to tighten and counterclockwise to loosen the headband.
P Fan Intake – The fan pulls in air and circulates the air throughout the
helmet.
Fiber-optic Cable – Available on the fiber-optic headlight helmet model
Q
only. This cable routes light from the fiber-optic light source to the
headlight.
R Audio Jack – When using a dictation device, use this jack to connect an
earphone.
S Power Cable – This built-in cable is compatible with the power cord and
holster combination, and the dictation power cord.
T Power Cord with Holster – This cord is supplied with all helmet models.
The holster holds standard and extended life power packs. The holster
swivels to hang from your waist band for either left or right handed
access.
U Power Cable Plug – This plug is used to connect to the appropriate
power cord. See the Accessories section.
V ACMI Fiber-optic Cable Plug with Cap – Available on the fiber-optic
headlight helmet model only. This plug is used to connect to an ACMI
compatible fiber-optic light source.

Symbol Definitions

The symbols located on the equipment and/or labeling are defined in this section
or in the Symbol Definition Chart. See the Symbol Definition Chart supplied with
the equipment.
Increase Decrease Microphone
Air Flow Air Flow
P
Q
R
S
T
U
General Refer to
Mute Warning Instruction
Sign Manual/
booklet
EN
Direct
Current
(DC)
3