Manual Mode - BH FITNESS G6511 Manual Del Usuario

Press and hold the PROGRAM and
MODE keys at the same time for 5
seconds approximately.
The units will change ("M" Miles or
"KM" kilometres).
OPERATING INSTRUCTIONS.-

MANUAL MODE

This monitor has program (MANUAL).
For programs MANUAL you can specify
the duration of the exercise between (5
to 99) minutes, distance between (1 to
99.9) and calories between (5 to 999).
Pressing the START/STOP key will light
the MANUAL and the machine will start
within 3 seconds,
countdown on the TIME display, at a
speed of 1.0km/h.
You can increase or decrease the
speed setting in MANUAL mode by
pressing the SPEED (↨) keys, between
1.0–22 km/h.
The machine will stop if you press the
START/STOP key or if you remove the
SAFETY KEY
PROGRAM MODE.-
This monitor
(MANUAL, P01; P02; P03; P04; P05;
P06; P07; P08; P09; P10; P11; P12;
P13; P14; U01; U02; U03; BODY-FAT).
For programs P1 to P14 you can
specify the duration of the exercise
between (5 to 99) minutes.
Program graphics for P1 to P14.
See end pages.-
With the machine ready, press the
PROGRAM key and P01 will appear
on the display, by pressing the
PROGRAM key you can access the
programs (P1 al P14: BODY-FAT).
Press MODE to select it.
After you have confirmed your chosen
shown by
has 20 programs
program, you will be prompted to
select the level (L1-L3). Use the
SPEED (↨) keys to choose the level
and press MODE to confirm and TIME
will begin to flash.
Use the SPEED (↨) keys to specify the
duration of the program (5 – 99
minutes). The monitor has a default
program setting of 30 minutes.
Press the START/STOP key and the
machine will start to operate after 3
seconds, shown by the countdown on
the central display, based on the
values it has been given.
You can change the speed settings at
any time during the exercise by
a
pressing the SPEED (↨) keys, and the
inclination settings by pressing the
INCLINE (↨) keys.
ECO FUNCTION.-
Press this button when in manual or
program mode to enter into economic
mode. The machine will change the
incline and configuration to reduce
power consumption and the time
window will alternate time with the
word ECO.
Press the ECO button again to exit
this function.
USER PROGRAM MODE.-
The user programs allow you to design
the speed and inclination graphs with
reference to your fitness level.
With the machine ready, press the
PROGRAM key and U01 will appear
on the display, by pressing the
PROGRAM key you can access the
user programs (U01; U02; U03), once
you have chosen a program press the
MODE key and the first step of the
program you are designing will be
shown in
10
the TIME/DISTANCE