Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 11
EN
For left-hand drive vehicles only.
› Coil the excess length of the white wire into a flat loop, and use the cable tie (E) to secure it
to the existing electrical wiring on the BCM control unit (see arrow in the detail).
Fig. 12
For the Fabia.
› Coil the excess length of the wiring harness (B) into a flat loop, and secure it to the existing
electrical wiring on the retaining bracket, along with the plug-in connection (C, D) (see arrow
in the detail).
Fig. 13
For the Rapid.
› Secure the wiring harness (B) to the plastic duct for the electrical wiring. Then coil the
excess length of the wiring harness into a flat loop and secure it to the existing electrical
wiring at the retaining bracket, along with the plug connection (C, D) (see arrows).
Fig. 14
Diagram showing how the wires in the wiring harness (B) are connected to the steering
column stalk connector, the retaining bracket, the BCM control unit and the engine con-
trol unit.
Check that all the wires of the wiring harness (B) are securely attached and seated. The
wires must be secured in such a way that they cannot become loose or damaged and so
that no interference noise occurs while driving. Secure the wiring harness in the area
underneath the instrument cluster with the utmost care so that it cannot become loose.
This prevents them from colliding with any other components located under the instru-
ment cluster (knee airbag, foot pedals, steering column, etc.).
Under no circumstances should the operation of the knee airbag, foot pedals or any other
components located underneath the instrument cluster be impaired. At the same time, it
must still be possible to remove the retaining bracket, as well as the plug on the
BCM control unit.
Refit all of the components that you removed earlier and tighten the respective connec-
tions to the specified tightening torques. Connect the vehicle battery and carry out all
steps for disconnecting and reconnecting the battery (see Repair Manual).
Activate the cruise control function as shown in table 15. Check that the cruise control
system is operating correctly when test driving the vehicle.
16
Publicidad
