Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xperience Traducción Del Manual Original

7.3 Switching the clipper on and off.

‹
‹
Fig. 4

7.4 Using the clipper

Approach the animal from the front.
‹
Secure the animal to be clipped and calm it down.
‹
Plug the power plug into the socket.
‹
Switch the clipper on while you are in the visual range of the animal.
‹
Observe the animal's behaviour while clipping.
‹
Switch the clipper off after you have finished clipping and pull the plug from the socket.
‹

7.5 Replacing the clipping blades

‹
‹
‹
‹
Fig. 5
30
All manuals and user guides at all-guides.com
To switch the clipper on, slide the ON/OFF
switch to the position I.
To switch the clipper off, slide the ON/OFF
switch to the position 0 (see Fig. 4).
Switch the clipper off by sliding the switch to
the position "0".
Pull the plug from the socket.
Turn the adjusting knob in the direction of the
arrow until the resistance decreases.
Place the clipper with the comb plate screws
facing up onto a flat surface.
Cattle clipper Xperience
‹
Fig. 6
Fig. 7
‹
‹
Fig. 8
Cattle clipper Xperience
Loosen the comb plate screws and remove the
clipping blade.
NOTE
► Make sure the clipping blades are
positioned correctly when installing the
new or sharpened blades.
Place the new upper blade onto the guiding tips
of the swivelling lever.
Apply a few drops of oil on the polished
surfaces of the upper blade.
31