Preparing The Remote Control Unit; Inserting Batteries; Cautions Regarding Batteries - Pioneer PDP-506HDG Manual De Instrucciones

Preparation

Preparing the remote control unit

Inserting batteries

1
Open the battery cover.
2
Load the supplied two AA size batteries while inserting
their respective negative polarity (–) ends first.
• Place batteries with their terminals corresponding to the
(+) and (–) indicators in the battery compartment.
3
Close the battery cover.

Cautions regarding batteries

Improper use of batteries can result in chemical leakage or
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline
ones.
• Place the batteries with their terminals corresponding to the
(+) and (–) indicators.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new
batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
• Remove batteries as soon as they have worn out. Chemicals
that leak from batteries can cause a rash. If you find any
chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter
life expectancy due to storage conditions.
• If you will not use the remote control unit for an extended
period of time, remove the batteries from it.
CAUTION
• WHEN DISPOSING OF USED BATTERIES, PLEASE
COMPLY WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTRUCTION'S RULES
THAT APPLY IN YOUR COUNTRY/AREA.
All manuals and user guides at all-guides.com
Allowed operation range of the remote control
unit
Operate the remote control unit while pointing it toward the
remote control sensor (t) located at the bottom right of the
front panel of the Plasma Display. The distance from the
remote control sensor must be within 7 m and the angle
relative to the sensor must be within 30 degrees in the right,
left, upward, or downward direction.
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock. In addition,
• Do not install or place the remote control unit under direct
• The remote control unit may not work properly if the remote
• When any obstacle exists between the remote control unit
• As the batteries become empty, the remote control unit can
• The Plasma Display emits very weak infrared rays from its
• Depending on the installation environment, infrared rays
30º
do not expose the remote control unit to liquids, and do not
place in an area with high humidity.
sunlight. The heat may cause deformation of the unit.
control sensor of the Plasma Display is under direct sunlight
or strong lighting. In such case, change the angle of the
lighting or Plasma Display, or operate the remote control
unit closer to the remote control sensor.
and the remote control sensor, the remote control unit may
not function.
function within a shorter distance from the remote control
sensor. Replace the batteries with new ones early enough.
screen. If you place such equipment operated through
infrared remote control as a VCR nearby, that equipment
may not receive commands from its remote control unit
properly or entirely. If this is the case, place that equipment
at a location far enough from the Plasma Display.
from the Plasma Display may not allow this system to
properly receive commands from the remote control unit or
may shorten allowable distances between the remote
control unit and the remote control sensor. The strength of
infrared rays emitted from the screen differs, depending on
images displayed on the screen.
05
7 m
30º
Remote control
sensor
19
En