Power Control; Power Management (Pc Mode Only) - Pioneer PDP-506HDG Manual De Instrucciones

Adjustments and Settings

Power Control

Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Save1", "Save 2" or "Picture Off" ( /
ENTER).
Item Description
Standard Does not decrease the picture brightness.
Save1 Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers
power consumption.
Picture Off Deactivates the screen to save power. To restore
the screen display, press any button other than
i +/i – and e.
This setting is not memorised by the system.
5
Press HOME MENU to exit the menu.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
then ENTER).
Select "Enable" ( /
Item Description
Disable
Does not place the system into the standby
(factory default) mode.
Enable Places the system into the standby mode if no
signal is received for 15 minutes.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
program finishes.
All manuals and user guides at all-guides.com
then ENTER).
then ENTER).
then
then ENTER).
then ENTER).
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Operation off" ( /
4
then ENTER).
Select "Enable" ( /
Item Description
Disable Does not place the system into the standby
(factory default) mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.

Power Management (PC mode only)

The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Power Management ( /
4
Select "Mode 1" or "Mode 2" ( /
Item Description
Off No power management
(factory default)
Mode1 • Places the system into the standby mode
when no signal is received from the personal
computer for eight minutes.
• Even when you start using the computer and
a signal is received again, the system stays
off.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
a on the remote control unit.
Mode2 • Places the system into the standby mode
when no signal is received from the personal
computer for eight seconds.
• When you start using the computer and a
signal is input again, the system is switched
on.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or TV
a on the remote control unit.
5
Press HOME MENU to exit the menu.
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
09
37
En