Switching The Vertical Drive Frequency; Adjusting Image Positions And Clock Automatically (Pc Mode Only); Adjusting Image Positions And Clock Manually (Pc Mode Only) - Pioneer PDP-506HDG Manual De Instrucciones

Adjustments and Settings
09

Switching the vertical drive frequency

You can switch the vertical drive frequency for screen display
between 75 Hz and 100 Hz. Choose the drive frequency that
better suits your broadcasting signals.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Drive Mode" ( /
4
Select 75 Hz or 100 Hz ( /
Drive Mode
75Hz
100Hz
5
Press HOME MENU to exit the menu.
NOTE
• Selection can be performed for each input source
separately.
• Selections are effective only for the following input signals:
PAL/SECAM (576i, 576p, 1080i@50Hz, 720p@50Hz)
• Selections are ineffective for 1080p@24Hz.
• If you select "Auto" for "Side Mask" (page 40), the selection
for "Drive Mode" becomes ineffective.
Adjusting image positions (AV mode
only)
Adjust the horizontal and vertical positions of images on the
Plasma Display.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Position" ( /
4
Select "H/V Position Adjust" ( /
Position
H/V Position Adjust
Reset
5
Adjust the vertical position ( / ) or the horizontal
position ( / ).
6
Press HOME MENU to exit the menu.
NOTE
• To restore the factory defaults for all items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
• Adjustments are stored separately according to input
source.
38
En
All manuals and user guides at all-guides.com
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
/
/ to select "Yes", and
Adjusting image positions and clock
automatically (PC mode only)
Use Auto Setup to automatically adjust the positions and clock
of images coming from a personal computer.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Auto Setup" ( /
Option
Auto Setup
Manual Setup
• Auto Setup starts.
4
Press HOME MENU to exit the menu.
NOTE
• When Auto Setup is finished, "Auto Setup completed."
appears.
• Even when "Auto Setup completed." appears, Auto Setup
may have failed, depending on conditions.
• Auto Setup may fail with a PC image composed of similar
patterns or monochrome. If not successful, change the PC
image and try again.
• Be sure to connect the computer to the Media Receiver and
switch it on before starting Auto Setup.
Adjusting image positions and clock
manually (PC mode only)
Usually you can easily adjust the positions and clock of images
using Auto Setup. Use Manual Setup to optimize the positions
and clock of images when necessary.
1
Press HOME MENU.
2
Select "Option" ( /
3
Select "Manual Setup" ( /
4
Select the item to be adjusted ( /
Manual Setup
H/V Position Adjust
Clock
Phase
Reset
5
Perform adjustment ( /
to
• With "Clock" or "Phase" selected, you can change the
parameter using
6
Press HOME MENU to exit the menu.
NOTE
• To restore the factory defaults for all the items, press
select "Reset" in step 4, and then press ENTER. A
confirmation screen appears. Press
then press ENTER.
then ENTER).
then ENTER).
then ENTER).
then ENTER).
then ENTER).
0
0
and / ).
/ .
/ to select "Yes", and
/ to