Connecting Control Cords - Pioneer PDP-506HDG Manual De Instrucciones

Enjoying through External Equipment

Connecting control cords

Connect control cords between the Media Receiver and other
PIONEER equipment having the t logo. You can then operate
the connected equipment by sending commands from its
remote control unit to the remote control sensor on the Plasma
Display.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Display when operating the connected equipment.
NOTE
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.
About SR+
The CONTROL OUT terminal on the rear of the Media Receiver
supports SR+ that allows linked operations with a PIONEER AV
receiver. SR+ presents functions such as the input switch
linkage operation function and the DSP surround mode display
function. For more information, see the user's manual for the
PIONEER AV receiver supporting SR+.
NOTE
• While in connection through SR+, the volume on this system
is temporarily minimized.
Media Receiver (rear view)
I N OUT
SERVICE ONLY
CONTROL MONITOR OUT
R-AUDIO-L VIDEO
INPUT 3
ANT IN
INPUT 2
Y C /P C /P
R-AUDIO-L VIDEO S-VIDEO B B R R HDMI BLACK
SUB
WOOFER INPUT 1 COMPONENT VIDEO INPUT 3 SYSTEM CABLE
I N OUT
CONTROL
The control cables (commercially available) are
monaural cables with mini plugs (no resistance).
All manuals and user guides at all-guides.com
AC IN
WHITE
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
11
49
En