Energetics E-205 Instruccion De Uso página 30

User Manual
Service
Troubleshooting
Error message
E: The computer receives no signal during the Recovery Program.
ERR: The computer receives no signal in the BMI-BMR-Fat Program test
mode .
ERR2: There is no connection between power board and computer or the
power board is defective .
Solution: see . "The computer display is not working" .
The computer display is not working
• The computer might not be getting power. Check all connections and
cables .
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer .
Heart rate (PULSE) is incorrect or not displayed at all
Monitoring via the hand pulse sensor:
• Check if your hands have proper contact with the sensors. Both hands have
to be placed on the sensors simultaneously . There might be a slight delay
before the read out appears .
• Check all cable connections.
• Try moistening your hands slightly if they are very dry.
Monitoring via the chest strap (optional):
• Not all available chest straps are compatible with the E-205. Check if your
chest strap runs on a frequency of between 5,4 – 5,7 Hz .
• The battery of the chest strap is too weak and needs replacing.
All manuals and user guides at all-guides.com
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge . Normally the E-205
restarts on its own .
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it .
Care
Take care that to avoid any moisture penetration . Clean the computer with a
lightly dampened cloth . Do not use abrasive cleaning solutions .
Maintenance
There is no need for special maintenance . Regularly check that all bolts and
connections have a tight fit . Exchange any defective parts immediately . For
assistance contact your local ENERGETICS-dealer .