Electrical Installation - GOK BC-2 Instrucciones Para El Montaje Y El Funcionamiento

Proteccion contra sobrellenado
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96
Can result in short circuit or electric shock.
Do not use the device if the insulation is damaged!
Have new insulation installed by a specialised company!
Observe the safety precautions and the assembly and operating instructions of
connected devices.
External lines (network current, feelers (probes), etc.) are connected via spring-loaded
terminal blocks (permissible transverse section of the connection cables up to 2.5 mm²).
Indicator Type BC-2 – sectional view

ELECTRICAL INSTALLATION

Connection Lines between the Indicator and the sensor
Line cross-section
maximum length
Version
Port
Supply voltage
Supply voltage
30 / 133
Damaged or destroyed insulation!
Danger to life due to electric shock!
Electric shock from touching live parts.
Disconnect the power.
Only touch the probe when the display unit is not supplied with
power.
Only place under tension after ending all work.
2
2 x 1mm
(Cu)
100m
e.g. H05VV-F ; NYM or similar
Probe
230VAC 50Hz
e.g.: NYM
2
2 x 1.5mm
(Cu)
100m
Extension via special accessories
for cable connection fitting
Terminals 4 and 5 - sensor
Connection to terminals L1 and N1
Line cross-section 1.5 – 2.5 mm²
BC-2
Artikel-Nr. 15 707 50

Publicidad

Tabla de contenido
loading

Tabla de contenido