Cleaning, Storage And Maintenance; Resetting The Blades; Test Cut Using Newspaper; Warranty - Brill Classic 30 Manual Del Usuario

4. Resetting the blades

Before leaving our factory, the
blades of your new hand mower
were set optimally. If the cut
becomes uneven after long use,
correct the bottom blade setting.

5. Test cut using newspaper

After you have reset the cutters,
make a test cut using newspaper.

6. Cleaning, storage and maintenance

After use, clean the mower and oil
lightly. Grease the cutters. The
symbols in Figure E indicate which
parts of the hand lawn mower can
be lightly oiled or greased
Store the mower in a dry place.
Regrinding the cutters,which is not
required until after years of use if
the mower is looked after properly,
may only be carried out by on
authorised dealer because of the
grinding method required to do
this work correctly.
7. Mowing with the grass catcher
Using the grass catcher (Art. No.
65041) saves you having to rake
the grass cuttings together after
mowing. The grass catcher can
be supplied by your dealer.

Warranty

The manufacturer warrants its prod-
ucts for exclusively non-commercial
use for a period of 24 months from
the date of original purchase.
This warranty does not affect statu-
tory warranty claims. The warranty
covers all substantial faults of the
product, which are caused by
defects in material and workman-
ship. If a product exhibits such a
defect we will, at our option, repair
or replace it without cost for parts
All manuals and user guides at all-guides.com
(Fig.C)
Turn the setting nuts on both sides
slightly to the righr to set the bot-
tom blade until it is just in contact
with all the cutters over the whole
length of the cutting roller
(Fig. D)
(Fig. E)
The hand lawnmower must only
be repaired and the blade must
only be replaced at qualified
workshops.
.
Where possible, have your mower
inspected in autumn, so that it is
ready for immediate use in the
following spring.
A
Attention!
For safety reasons use only manu-
facturer's original parts or parts
released by the manufacturer.
(Fig. F)
The grass catcher functions best
when the lawn is dry and you
push the mower at a quick walking
pace.
and labour provided the following
requirements are fulfilled:
The product must have been
.
sold to the customer in a legally
correct way.
The original receipt with the
.
customer's address, date of pur-
chase, model and product desig-
nation is presented as proof of
purchase. The product must have
been purchased within the EC.
The product was handled proper-
.
ly and according to the recom
A
Attention:
Take extra care when working
on the cutters (danger of injury).
We would like to point out express-
ly that we are not liable under the
Product Liability Act for damage or
injuries caused by our appliances
if these were caused by incorrect
repairs or if replacement parts
were used which were neither
manufacturer's original parts or
parts released by the manufacturer
and the repair was not carried
out by an authorised after-sales
service provider or an authorised
dealer. This applies analogously for
extension parts and accessories.
mendations in the operating
instructions. It is essential that the
product has been maintained
and cleaned according to the
information in the operating
instructions. No attempt to disas-
semble or repair the product has
been made by either the buyer or
an unauthorised third party.
It must be ensured that only
.
original replacement parts and
original accessories approved
by the manufacturer are used.
GB
11