Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. INSTALL BACKSPLASH
Backsplash must be installed before the hood shell because the hood shell covers the
backsplash top mounting screws. In order to be able to install the backsplash, make sure you
have at least 18'' clearance between bottom of hood and range control panel or cooktop.
(See instructions packed with backsplash.)
5. INSTALL WOOD MOUNTING STRIP
Measure and mark a level line on wall above cooktop location for the wood mounting strip
(see illustration under step 2 for dimensions). Center wood mounting strip (provided) over location.
Use #10 - 2'' flat head screws to secure the mounting strip to the drywall. Make sure to hit the
wall studs.
CAUTION
Due to the weight of
this hood, ensure
that the wood strip
is attached to all of
the available studs
(2 studs minimum
for a 30'' hood, more
as
hood
width
increases); not into
the drywall alone.
6. INSTALL THE HOOD
Rest the back cavity of the hood on the wood mounting strip.
Hold the hood until it is completely secured to the wood mounting strip.
Secure the hood to
wood mounting strip
with (4) screws #8 x 3/4"
(for 30" and 36" width
hoods) or (6) screws
(for 42" width and
wider hoods) provided
at locations shown.
Drill (2) 3/16'' size
holes into the drywall
for
wall
anchors
through the existing
holes in the inside
hood back in the locations shown. Then, install the two wall anchors and attach the hood with
the remaining #8 x 3/4" screws and the (2) washers provided.
7. SELECT BLOWER OPTION (EXTERIOR OR INTERIOR)
INTERIOR BLOWER:
EXTERIOR BLOWER:
(OPTIONAL)
W
OOD
(C
ENTERED HORIZONTALLY
WALL STUDS OR FRAMING
L
L
EVEL
INE
(
6
SEE PAGE
)
FOR DIMENSIONS
HD0046
CAUTION
HD0047
Follow all subsequent steps of this manual.
Refer to instructions packed with exterior blower and follow steps 9,
and up of the present manual.
- 7 -
S
TRIP
&
SECURED TO
)
T
(
OP OF HOOD
INSIDE VIEW
M
OUNTING SCREW LOCATIONS
B
(
ACK OF HOOD
INSIDE VIEW
W
ALL ANCHORS LOCATIONS
)
)
Publicidad
Tabla de contenido
