Downrod Style Fan Mounting; Gg Pin (In Downrod); Hh Clip (Attached To Pin) - Harbor Breeze E-PEN44BCW5MC Manual De Instrucciones

DOWNROD STYLE FAN MOUNTING

1. Remove pin (GG) and clip (HH) from
downrod (A). (Fig. 1A) Partially loosen set
screws in motor housing yoke at top of motor
housing (E). (Fig. 1B)
*Helpful Hint: Downrod style mounting is
best suited for ceilings 8 ft. (2.44 m) high or
higher. For taller ceilings you may want to use
a longer downrod (not included) than the one
provided. Angle style mounting is best suited
for angled or vaulted ceilings. A longer
downrod is sometimes necessary to ensure
proper blade clearance.
2. Insert downrod (A) through canopy (B) and
yoke cover (D). Thread wires from motor
housing (E) through downrod (A). (Fig. 2)
3. Slip downrod (A) into motor housing yoke, align holes
and re-install pin (GG) and clip (HH). Re-tighten set
screws in motor housing yoke and then tighten nuts.
Slide yoke cover (D) down until it rests on top of motor
housing (E). (Fig. 3)
All manuals and user guides at all-guides.com
Fig. 1A
A
HH
Hardware Used
GG
Pin
HH Clip
Hardware Used
GG
Pin
HH
Clip
8
Fig. 1B
A
Set
Screw
GG
Fig. 2
A
D
Fig. 3
A
D
HH
Set Screw
GG
E
E
x 1
x 1
B
x 1
x 1