Setting The Advance Speed; Cleaning; Shutting Down The Appliance; Emptying The Dirt Water Reservoir - Kärcher Tornado BR 40/25 C Bp Manual De Instrucciones

Setting the advance speed (BD
model only)
Turn the running gear to the front with
your foot.
Reducing the speed: Turn the wheel in –
direction.
Increasing the speed: Turn the wheel in
+ direction.

Cleaning

Turn the running gear to the back with
your foot.
Turn the program selection switch to the
desired cleaning program.
Set the water quantity according to the
degree of dirt accumulation and the floor
covering.
Lower the vacuum bar.
Turn on the brushes by pulling the con-
trol handle.
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.

Shutting Down the Appliance

Close the water quantity regulator.
Drive the appliance forward for another
1-2m to draw off residual water.
Turn the program selection switch to
"OFF".
Raise the vacuum bar.
Swing the running gear to the front using
your foot.
12
English
Warning!
Danger of deformation of the brush(es).
When shutting down the appliance, relieve
the brush(es) by swinging the running gear
forward.

Emptying the Dirt Water Reservoir

Note
If the dirt water reservoir is full the float clos-
es the suction channel. The suction opera-
tion is interrupted. Empty the dirt water
reservoir.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Take the dirt water discharge hose from
the support and lower above a suited col-
lection device.
Let off water by opening the dosage de-
vice at the discharge hose.
The rinse the dirt water reservoir with
clear water.
Emptying the fresh water tank
Release the coupling at the upper end of
the fill level display.
Lower the hose for the fill level display
into a suitable collector and drain off liq-
uid.
Engage the coupling on the appliance
again.

Transport

If you want to transport the appliance on
a vehicle secure it from slipping.