Faults With Display; Faults Without Display - Kärcher Tornado BR 40/25 C Bp Manual De Instrucciones

Battery con- Overload
trol display display
– flashes
rapidly
– flashes
slowly
– lights
rapidly flash- flashes
es red rapidly
slowly flash- flashes
es red slowly
Fault
Appliance cannot be start-
ed
Insufficient water quantity
Insufficient vacuum per-
formance
Insufficient cleaning result Check the brushes for wear, replace if required
Brushes do not turn

Faults with Display

Fault
Brush drive ex-
cess temperature
Wrong cable con-
nections will lead
to disruptions and
overload on the
brushes.
Electronic fault
Defective battery
Short circuit cus-
tomer

Faults without Display

Remedy
Check batteries, charge if necessary
Check battery pole fuse at the plus pole of the battery (75A);
if the fuse is defective, call customer service.
Check the fresh water level, refill tank if required
Check if the hoses are blocked, refill tank if required
Clean the seals between dirt water reservoir and cover and
check for tightness, replace if required.
Clean the fluff filter
Clean the vacuum lips on the vacuum bar, replace if required
Check if the suction hose is blocked, clean if required
Check the suction hose for tightness, clean if required
Check that the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Check if foreign bodies are blocking the brushes, remove for-
eign bodies if required
Remedy
Switch the program selection switch to
OFF and let the appliance cool down.
Switch program selection switch to OFF.
Then reselect the cleaning program. Call
customer service if fault persists.
Set program switch to OFF. Wait for a
while. Select the cleaning program
again. If the fault recurs, call customer
service.
15
English