Chapter 7: Documentation; Form For Set Values Of Bwt Bestaqua 22,24,26 Hq - BWT Bestaqua 22 HQ Instrucciones De Montaje

7.1 Form for set values of BWT bestaqua 22,24,26 HQ

Note: Please copy a blank page of these form. Then fill out the following table at every initial and further installation and
archive the data-sheet.
Date of installation:
Customer:
Model / serial number:
Observe: The settings 1-3 may be changed by the customer
Parameter: Parameter:
DATE:
TIME: TIME:
LANGUAGE:
Start- / stop pressure setting: Start- / stop pressure setting:
(PRESSURE TANK OPERATION)
(PRESSURE TANK OPERATION)
STOP PRESSURE:
Membrane flushing (FLUSH TIME): Membrane flushing (FLUSH TIME):
CONDUCTIVITY LIMIT:
CONDUCTIVITY ALARM: CONDUCTIVITY ALARM:
MAX PUMP PRESSURE:
Setting of blending Setting of blending
Actual software version:
..... / ..... / ..........
& the settings 4-9
Value set at installation: Value set at installation:
[Day / month / year]
[Hours : minutes] [Hours : minutes]
Language selection
bar r bar
bar
Seconds Seconds
μS/cm
Deactivated /ENABLE Deactivated /ENABLE
internal: 8 ... 13 bar
e.g.: steamer 70μS e.g.: steamer 70μS
FOR BWT SERVICE
Service technician:
only by an authorized service technician.
Description: Description:
Current date
Current time Current time
Active language: English
Pressure tank „YES": switch-off point 2-4 bar; Pressure tank „YES": switch-off point 2-4 bar;
Switch 0.3-1.6 bar and below the switch-off point;
Switch 0.3-1.6 bar and below the switch-off point;
Pressure tank „NO": with switch-off point 2 bar Pressure tank „NO": with switch-off point 2 bar
Online: P = 4.0 bar, Offline: P
max
0 ... 60s (default setting 15s) 0 ... 60s (default setting 15s)
Default setting: 200 μS/cm
Default setting: "ENABLE" Default setting: "ENABLE"
Default setting: 9 bar
Factory setting: no blending Factory setting: no blending
Only for BWT Service technicians
EN
= 2.0 bar
max
49