Chapter 3: Operation And Programming Of The Software; Quick Operation Guide; Function Keys And Display Elements - BWT Bestaqua 22 HQ Instrucciones De Montaje

EN

3.1 Quick operation guide

The BWT bestaqua 22,24,26 HQ devices could be controlled and parameterised with the control unit.
The display of the RO unit shows after the starting phase all currently measured operating values.

3.2 Function keys and display elements

Pressure permeate:
Pump pressure:
Permeate flow:
Status displays:
READY ; PAUSE ;
Feed water temperature:
WORKING, FLUSH
Permeate conductivity:
Fig. 4: Display: with activated detail menu
By pressing the [ON/OFF] button the device switches
from Ready to Pause or ON/OFF.
(Arrow up) button Scrolls through the menu
[ ]
pages upward or increases the value of the
parameter presently shown on the display.
(Arrow down) button Scrolls through the menu
[ ]
pages downward or decreases the value of
the parameter presently shown on the display.
Confirmation button Confirmation of the
[ ]
parameter presently shown on the display and
performs partially (analogy to each of the units
mode) a reset in case of alarms and/or failures.
34
4 Control keys for the menu and parameter
selection [O], [ ], [ ], [ ]
General status:
μS/ppm: When the RO unit is in production, the value of
conductivity in
μS
»
with the activation of the detail screen by tapping the
arrow keys.
ready: "READY" for a new consumption demand.
In the online mode the unit starts automatically
when the permeate pressure falls below the
presetted starting pressure.
RO unit stops the permeate production.
pause:
Observe: The unit doesn't start in case of
a new emerging permeate demand.
Only in the mode
programmable.
working: RO unit is in production ... "WORKING".
By pressing the [ON/OFF] button the production
is interrupted and the "PAUSE" message appears,
by a repeated pressing the production start again.
The RO unit rinses ...
flush:
that automatically to the operating step "READY".
Optionally available, Item no. 824047:
The RO unit can be equipped with the additional
"EXT. PAUSE":
I/O installation kit, started and stopped due to the triggering of
an external NO potential free signal.
READY ; PAUSE ;
device [ON/OFF]
or TDS in can be shown,
ppm
« » «
is your RO unit
"PAUSE"
and switches after
"FLUSH"