Maintenance; Dismantling; Disposal; Spare Parts - Calpeda NCE H Serie Instrucciones De Uso

7.10. Switch off of the pump
ON
EN
The appliance must be switch off every time there
are faults. (see troubleshooting).
The product is designed for a continuous duty, the swit-
ch off is performed by disconnecting the power supply by
means the expected disconnecting devices. (see para-
graph "6.5 Electrical connection").

8 MAINTENANCE

Before any operations it's necessary to disconnect the
power supply.
If required ask to an electrician or to an expert techni-
cian.
Every maintenance operations, cleaning or
reparation executed with the electrical system
under voltage, it could cause serious injuries to
people.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
In case of extraordinary maintenance, or maintenance
operations that require part-removing, the operator must
be a qualified technician able to read schemes and
drawings.
It is suggest to register all maintenance operation execu-
ted.
During maintenance keep particular attention in
i
order to avoid the introduction of small external
parts, that could compromise the device safety.
It is forbidden to execute any operations with the
direct use of hands. Use water-resistant, anti-cut
gloves to disassemble and clean.
During maintenance
i
personnel is not allowed.
Maintenance operations that are not described in this
manual must be made only by special personnel authori-
zed by Calpeda S.p.A.
For further technical information regarding the use or the
maintenance of the device, contact Calpeda S.p.A.
8.1 Routine maintenance
OFF
Before every maintenance operations disconnect
the power supply and make sure that the device
could not accidentally operate.
The pumps are made to function for many years in nor-
mal conditions with no need for maintenance.
At the beginning of each eating period, or after a
prolonged stand still, verify that the pump is not
jammed.
If the pump is jammed follow the manual cleaning
procedure described in the next paragraph.

9. DISMANTLING

OFF
Close the suction and delivery valves and drain the pump
casing before dismantling the pump.
Page 12 / 72
operations external
NCE(D) H, NCE(D) HQ Rev. 5 - Operating Instructions
The motor and all internal parts can be dismantled
without removing the pump casing and the pipes.
Before any servicing operation disconnect the
electrical power and wait until the water has
cooled inside the
pump, if is not possible use the suitable
protective devices to prevent the risk of
burns.
By removing the screws (chap. 13.2 fig. 6) the motor is
taken out complete with impeller.
Disassemble the motor and clean the impeller.

10. DISPOSAL

OFF
The final disposal of the device must be done by speciali-
zed company.
Make sure the specialized company follows the classifica-
tion of the material parts for the separation.
Observe the local regulations and dispose the device
accordingly with the international rules for environment
protection.

11 SPARE PARTS

11.1 Spare-parts request
When ordering spare parts, please quote the data stam-
ped on the name-plate (type, date and serial number).
The spare parts request shall be sent to CALPEDA S.p.A.
by phone, fax, e-mail.
Changes reserved.