AHT GD Serie Manual De Instrucciones página 34

8 | Setup and installation
Insertion of grille
– Place the grille on the bottom shelf.
Grille (1), bottom shelf (2)
Install display shelves
LED bars are pre-installed on display shelves.
CAUTION
Improper installation of the display
shelves.
Risk of injury due to falling of the display
shelves holding goods.
▪ The bracket for the display shelves and the
display shelves must fully engage in the
slots provided during suspension.
NOTICE
Material damage due to deformation of the
display shelves.
▪ Align the brackets in parallel.
▪ Align the display shelves horizontally.
Number and position of display shelves
Number of shelves see →Technical data
Install display shelves with LED bars
Connecting cables are located on the inside of the
rear panel, on the right-hand side.
Bracket types
– Brackets with cable duct for right side
– Brackets with cable duct for left side
– Pull the connecting cable for the LED bar out of
the rear panel of the appliance and lead it through
the cable duct from the bracket.
1
Fig. 3: Connecting cable (1), cable duct (2), right bracket (3)
34 / 478
– Attach the brackets for the display shelves to the
1
2
Fig. 4: Attach bracket (1) to openings (2)
– Attach the display shelves to the brackets.
Fig. 5: Attach display shelf (1) to bracket (2)
Material damage due to cable damage.
▪ Do not lay the cables over the bracket.
Fig. 6: Display shelf (1), right bracket (2), connecting and
light cable (3)
– Connect the plug of the connecting cable to the
2
3
Fig. 7: LED bars: Connect cables
LED bar is connected to power supply.
AHT Cooling Systems GmbH | en
openings of the attachment rails.
1
NOTICE
1
plug of the light cable. The plug connection must
snap into place.
2
1
2
2
3
405861_1_0819