Yamaha WARRIOR Manual Del Propietário página 296

Tabla de contenido

Publicidad

a. Cable length (46 ~ 50 mm)
a. Longueur de câble (46 à 50 mm)
a. Longitud del cable (46 ~ 50 mm)
4. Tighten the adjusting bolt locknut on the
clutch lever.
5. Screw in the adjusting bolt on the brake cali-
per by hand until it feels tight, then screw it
out 1/8 turn. Tighten the adjusting bolt locknut
to the specified torque.
Tightening torque:
Locknut:
16 Nm (1.6 m·kgf)
CAUTION:
_
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that the adjusting
bolt does not turn together with the locknut.
_
WARNING
_
Operating with improperly adjusted brakes
could cause the brakes to malfunction, result-
ing in reduced braking performance. This
could increase the chance of a collision or ac-
cident. After adjusting the parking brake, block
the rear of the machine off the ground and spin
the rear wheels. Check to make sure there is
no brake drag. If brake drag is noticed, perform
the adjustment again.
8-53
_

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Yfm350xp

Tabla de contenido