Engine Oil - Yamaha WARRIOR Manual Del Propietário

1. Dipstick
3. Minimum level mark
1. Jauge
3. Repère de niveau minimum
1. Varilla
3. Marca de nivel mínimo
2. Maximum level mark
2. Repère de niveau maximum
2. Marca de nivel máximo

Engine oil

Engine oil level measurement
1. Place the machine on a level surface.
2. Warm up the engine for several minutes, and
then stop it.
3. Remove the dipstick, and then wipe it off with
a clean rag. Insert the dipstick in the filler hole
without screwing it in.
NOTE:
_
Wait a few minutes until the oil level settles before
checking.
_
4. Remove the dipstick, and then check the oil
level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.
CAUTION:
_
Be sure no foreign material enters the crank-
case.
_
8-15
EBU00949*