Kobalt SGY-AIR70NB Manual Del Usuario página 12

OPERATING INSTRUCTIONS
1. Adjust the direction of the fan by loosening the air cap
ring (H or K) by hand and turning the air cap (C or K) to
either the horizontal or vertical direction. Tighten the air
cap ring by hand.
2. Set pattern size for desired shape. For full pattern, open
spray pattern adjustment knob (D) by turning
counterclockwise. For a round pattern, turn spray pattern
adjustment knob (D) clockwise (See Figure 2).
3. With the spray gun 6 in. to 12 in. away from workpiece,
spray a short burst while turning the fluid knob
counterclockwise. Observe the spray pattern on the
workpiece and adjust the fluid adjustment knob (E) until
desired pattern/atomization is obtained. If the spray is too
fine (caused by too much air), reduce the air pressure
or open the fluid adjustment knob (E) to spray more paint.
If the spray is too coarse (or is spitting blobs), reduce the
amount of paint with the fluid adjustment knob (E) or
thin the paint more (See Figure 3).
NOTE: The fluid adjustment knob (E) can be adjusted either
clockwise or counterclockwise to finely adjust the pattern
consistency. Before spraying on workpiece, practice a few
minutes on a scrap workpiece to ensure that the pattern
size and consistency are set correctly.
H or K C or K
12
1
Horizontal Fan
Vertical Fan
2
D
3
Paint too fine
Correct
Paint too coarse
Pattern Consistency (Atomization)