Kobalt SGY-AIR70NB Manual Del Usuario página 18

CARE AND MAINTENANCE
RE-ASSEMBLING SPRAY GUN
1. Screw the Fluid Nozzle (B) into the face of the spray
gun by turning it clockwise, using the a 9/16 in or
14 mm wrench to tighten securely.
(See Figure 1).
NOTE: Do not over tighten.
2. Insert the air distribution ring (L) over the fluid nozzle
(See Figure 2).
3. Screw the Air Cap Ring (C) onto the face of
the spray gun by turning it clockwise and
hand tighten (See Figure 3).
4. Slide the Paint Needle through the back of the
Spray Gun (See Figure 4).
5. Slide Needle Spring over the Paint Needle
(See Figure 5).
1
2
3
4
5
18
Clockwise
B
L
C
Clockwise