Kobalt SGY-AIR70NB Manual Del Usuario página 17

CARE AND MAINTENANCE
8. Using a 9/16 (14 mm) wrench, unscrew the Fluid Nozzle
(B) by turning counterclockwise and place it
in the secondary container to soak.
9. After 3-5 minutes, remove each item and use a clean dry towel to wipe
off the entire item and inspect it for any remaining paint or dirt remains.
IMPORTANT: To ensure all residue of material is removed from the part, use
a blow gun with an approved OSHA gun tip to blow any excess cleaning
solution off the part that a rag cannot get to.
If paint or dirt debris is still present, use a non-wire soft bristle brush and
brush the area.
NOTE:
Soaking of parts may require longer to get all paint residue off the
part.
17
8
Counterclockwise
B