Installation; General Preparation - Dovre ASTRO4GA-P Instrucciones De Instalacion Y Uso

The stove is delivered with a ceramic true-to-life
wood block set and is equipped on the inside at the
back with a black mirror for an even livelier flame
effect.

Installation

General preparation

Please check the appliance immediately after deliv-
ery for damage during transport or any other dam-
age or defects. The appliance is attached to the
pallet with screws at the bottom.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the detachable parts from the appliance
before you begin its installation.
It is easier to move the appliance and to avoid
damage if the removable parts have been
removed.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
The top plate (1) is loose on the stove and can
simply be lifted off of it; see next figure.
The door hooks on at the top of the stove and is
fastened at the bottom with a screw (2); see next
figure.
Subject to change because of technical improvements
The glass pane (1) can be removed by unscrewing
the glass fastener (2) at the top and pulling off the
U profiles on the side; see next figure.
The glass pane rests on a support at the bot-
tom (3). Do not remove this support.
Make sure you continuously support the glass
pane so that it does not fall and break.
7