Placing Decorative Wood Block Set - Dovre ASTRO4GA-P Instrucciones De Instalacion Y Uso

2. Place the micro switch on the connecting pins (2) that
are on the plastic cover of the gas control block (only
for the module with thermostat).
3. Connect the plugs (3) of the delivered cabling to the
driving motor and connect the plugs (4) to the micro
switch; see next figure.
There is only one way to do this, because the
plugs are different sizes.
4. Insert the batteries in the transmitter (handset) and in
the receiver (black box, lid can be opened easily).
5. Place the receiver (1) on the holder plate that is
behind the door at the bottom in the stove. Make sure
that the detection opening (2) and the lamp are vis-
ible; see next figure.
14
When operating the handset (see chapter 'Usage'), the
lamp on the receiver will light up and the motor will turn
the operating knob on the gas block.
Placing decorative wood block
set
Check whether the burner is in the correct position, as
it could have shifted during transport. The burner rests
loosely on the bottom of the combustion chamber, sup-
ported by the gas pipe holder on the back and by legs
at the front left and right; see next figure.
Subject to change because of technical improvements