Storage; Transport - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

EN
The distance should be equal at all times. If
necessary, you can set the correct level as
follows. Perform the adjustment on the left or right
adjustment segment [1] of the cutter deck:
Release the locknuts [2].
Î
To adjust the level, screw the adjusting screw [3]
Î
out or in until the level is correct.
Re-tighten the locknuts (77 Nm tightening torque).
Î
Note
Adjusting the side level can affect the level
from the front to the rear. Therefore, check
the value of the front to rear level and cor-
rect it as necessary.
Adjusting the cutter deck level from front to
rear Pb
Note
First check the side cutter deck level.
Park the device on an even surface and switch the
Î
parking brake on.
Bring the cutter deck to the middle height position.
Î
Carefully turn the outer cutters parallel to the drive
Î
direction.
Measure the distance between the ground and the
Î
end of the right cutter.
The blade end at the front should be about 2-6 mm
lower than the rear blade end. You may have to
adjust the front fixing bracket
Remove the protective cover [1] at the pitch arm.
Î
Release the locknuts [2] in an anti-clockwise
Î
direction.
To set the level, screw the nuts [3] in or out.
Î
Re-tighten the locknuts (77 Nm tightening torque).
Î
Fasten the protective cover back onto the pitch
Î
arm.

Storage

Attention!
Damage to appliance materials
¾ Store the device in a clean, dry enclosed space.
¾ Protect the device from rust when storing it for
lengthy periods of time.
¾ Protect the device from frost.
Clean the device and the grass catcher.
Î
Wipe all metal parts down with an oily cloth or
Î
spray them with oil to protect them from rust.
Charge the battery.
Î
Remove the battery in the event of long-term
Î
storage (e.g. over winter).
Charge up the battery every 6–8 weeks in the
Î
event of long-term storage and before reinstalling.
Drain the fuel and shut down the engine – see the
Î
engine manual.
Check the tyre pressure.
Î
24
[1] as follows:

Transport

Note
The device is not approved for public thor-
oughfares in accordance with national road
legislation (StVO).
Short distances
Switch off the cutter deck before driving the
Î
mower.
Prior to driving, move the cutter deck to the
Î
highest position (index 4.5).
Drive the machine only short distances to change
Î
its location of use.
Long distances
Danger posed by unstable and unsecured
ramps
ÂRisk of serious injury to people and sever
damage to property
¾ If you are pushing the device onto a
trailer or into a lorry, first make sure that
the ramp is stable and secure.
Danger posed by inadequate fastening
ÂTurbulence during transport
¾ If you are transporting the device in a
trailer or lorry, fasten it and secure it
adequately.
Attention!
Environmental hazard due to leaked fuel
¾ Do not transport the device in a tilted state.
Transport the device on a transport vehicle over
Î
long distances.
Manually push the device in neutral into/onto the
Î
transport vehicle. Pull both gear release levers O
back and press them downwards into the recess.
Activate the parking brake and secure the device
Î
against slipping.
WARNING!
WARNING!
Storage