Operation - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

Operation

Release the clamping screw [1]
Move the control lever [2] forwards or backwards
into the desired position
Re-tighten the clamping screw [1]
Note on adjusting the drive control lever:
Both levers should be installed at the same
position (height and length adjustment).
In the neutral position, with hands on the
control levers, the upper arms of the user
should be relaxed and approximately verti-
cal, while the lower arms should be approxi-
mately horizontal.
Note on drive control lever adjustment in
connection with seat adjustment
In the foremost position, the driver's back
should stay in contact the backrest, and
the drive control levers must not come into
contact with the legs of the user.
In the rearmost position, the drive control
levers should not come into contact with the
legs or the body of the user.
Set the seat to the desired operating posi-
tion.
Setting the cutter wheels
The cutter wheels should never be lower than
6-12 mm above the ground at the lowest cutter
position. The cutter wheels are not designed to bear
the loads generated by the cutters and may have
to be offset accordingly. They are used solely for
Always move the cutting wheels so they line up
evenly.
Note
The number of cutter deck wheels varies
depending on the model.
769-12264
:
.
.
.
Operation
Attention!
Also observe the information in the operating
manual for the engine.
Note
Comply with the national/municipal regula-
tions concerning the times when the appli-
ance may be used (if required, contact your
local authority).
Switching on/off the headlights
(optional; depending on the model)
To turn the headlights on, set the switch to "ON".
To turn the headlights off, set the switch to "OFF".
Opening the fuel tap
You can use the fuel tap to open and close the
supply of fuel to the left and right fuel tanks.
Fuel supply to both tanks shut
Fuel supply to right tank open
Fuel supply to left tank open
Engaging / disengaging the parking
brake
To engage the parking brake
drive control levers in neutral position right out into
the recess [A].
To release the parking brake, pull both drive
control levers inwards into the neutral posi-
tion [N] .
Attention!
Always switch on the parking brake before
leaving the device.
Setting the engine speed
using the throttle.
Fast engine speed =
Slow engine speed =
EN
, push both
17