Cleaning The Device; Servicing - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 119
EN
5 Operating
When the ignition is switched on,
hour counter
the battery voltage indicator is
displayed for a short period, which
then changes to the operating
hours indicator. The operating
hours are displayed in 1/10 hours.
The operating hours are always
counted except for when the igni-
tion key is in the "Stop" position or
when it is removed.
Note
displayed.
Type 1
Oil change display
Change the engine oil immediately (see engine
operating manual).
This indicator appears every 50 operating hours for
a period of 2 hours.
Type 2
Maintenance indicator
Change the engine oil immediately (see engine
operating manual).
This indicator appears every 50 operating hours for
a period of 7 minutes.
The engine oil level is too low.
Switch the engine off immediately and check
the engine oil level (see the engine operating
manual). Top up the oil if required.
22
If you turn the ignition key to the
operating hours.
Charge the battery as quickly as possible.
It may be necessary to have the charging system
checked by a service centre for possible damage.
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
Changing the oil
Changing the oil
Oil level

Cleaning the device

Do not use high-pressure cleaners for cleaning
the device.
Switch the parking brake on.
Clean the device with a scrubbing brush, hand
brush or a cloth.

Servicing

WARNING!
Risk of injuries or material damage
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
Remove the ignition key and the spark-
plug connectors.
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
Never reach into the rotating cutter
blades.
Only have repair and maintenance
work and the replacement of safety
specialist or a specialist service centre.
Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
Clean the device and all add-on and
accessory parts after every instance of
use.
Attention!
Servicing
Battery voltage
position, the
-
nance
769-12264

Publicidad

Tabla de contenido
loading

Tabla de contenido