Removing/Installing And Adjusting The Cutter Deck - Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales

Removing/installing and adjusting the cutter deck

cutter deck
WARNING!
Risk of injuries or material damage
Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
Remove the ignition key and the spark-
plug connectors.
Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
Never reach into the rotating cutter
blades.
Wear protective gloves.
Only have repair and maintenance
work and the replacement of safety
specialist or a specialist service centre.
Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
WARNING!
The suspension/lifter is spring-supported
and can spring back upwards once the cut-
ter deck is separated from the lifter.
When releasing the cutting height adjust-
ment lever with the cutting mechanism
removed, it can spring violently upwards.
Removal and installation must only be
performed by a service centre.
Ensure the cutting height adjustment
lever is always correctly secured with the
locking pin.
Disassembly
Park the device on an even surface and switch the
parking brake on.
Bring the wheels of the cutter deck into the
highest position.
Lower the cutting mechanism and bring it into the
lowest position.
Put the locking pin from outside right into the
position " " (above the cutting height adjustment
lever) and turn them down to secure them.
This secures the cutting height adjustment lever
located under the locking pin.
Remove the V-belt
(motor pulley) [2]. To do this, pull left or right
side of the V-belt backwards and then downwards
while manually turning the engine belt pulley in the
opposite direction.
769-12264
[1] from the PTO coupling
Note
Pull out the splint left and right cutter deck sus-
pension [3] [1] to separate the cutter deck
from the suspension unit. In doing so, support
ground.
Push the cutter deck forwards to separate it from
the front suspension unit
Place the cutting height adjustment lever upwards
into the highest mowing position.
Insert the locking pin into the highest mowing
position and let the cutting height adjustment lever
above it latch in on the locking pin.
Pull out the cutters from beneath the device.
Assembly
To reinstall the cutter deck, perform the steps in
the "Disassembly" section in reverse order.
Note
Following assembly, check that the V-belt is
positioned correctly and is not twisted
Park the device on an even surface and switch the
parking brake on.
Note
Before aligning the cutters check the tyre
pressure on the device.
When mowing does not appear to be parallel to the
lawn the cutters can be aligned.
level
Bring the cutter deck to the middle height position.
Carefully turn the outer cutters transverse to the
drive direction.
Measure the distance between the ground and the
ends of the two outer cutters.
The distance should be equal at all times. If
necessary, you can set the correct level as
follows. Perform the adjustment on the adjustment
segment [1] of the cutter deck:
Release the locknuts [2].
To set the level, turn the adjusting nuts [3].
Re-tighten the locknuts.
EN
[2].
.
25