Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales página 19

Operation
WARNING!
Always keep both hands on the drive
control levers.
When driving never let go of the drive
control levers.
Always move the drive control levers
by hand to neutral to slow or stop the
device.
Always move the drive control levers
slowly. Abrupt and hasty movements
and excessively sharp curves may lead
to involuntary movements, the device
crashing and thus to serious accidents.
Be particularly careful when reversing.
If, when driving in a straight line, the
device veers to one side, or the device
does not stay in a neutral position and
moves slightly (creeping), switch the
device off, discontinue using it and
contact a service centre.
Note
To decelerate or stop the device, bring both
control levers into the neutral position slowly
at the same time [N]
Sit down on the driver's seat.
Put on the seat belt.
Start the engine.
Release the parking brake by pulling both drive
control levers inwards into the neutral posi-
tion [N] .
To drive away, actuate the drive control levers as
follows:
Driving straight ahead
Press the two control levers forwards evenly. The
further they are pressed forwards, the faster the
device moves.
Taking a left forward turn
Push both control levers forwards; the right control
lever a little further than the left one.
Taking a right forward turn
Push both control levers forwards; the left control
lever a little further than the right one.
Note on taking corners
The greater the distance between the two
control levers, the tighter the corner taken.
Reversing in a straight line
Pull both control levers backwards evenly. The
further they are pressed backwards, the faster the
device moves.
769-12264
Taking a left backward turn
Taking a right backward turn
.
Right or left pivot turn
In the event of poor/low traction conditions, proceed
as follows:
Turning clockwise
Turning anti-clockwise
Slowing or stopping the device
Push both control levers backwards; the right
control lever a little further than the left one.
Pull both control levers backwards; the left control
lever a little further than the right one.
To stop the device, bring both control levers into
the neutral position.
Push the left control lever forwards, while at the
same time pulling back the right one.
To stop the device, bring both control levers into
the neutral position.
Push the right control lever forwards, while at the
same time pulling back the left one.
Note on performing a zero turn
During a zero turn, one wheel rotates in the
forward direction, the other backwards. A
badly executed zero turn can damage your
lawn.
To stop the device, bring both control levers into
the neutral position.
Depending on the direction, move one control
lever forwards or backwards with the other one at
neutral.
Note
During a pivot turn, only one wheel rotates.
The neutral wheel is locked and may cause
damage to your lawn.
To stop the device, bring both control levers into
the neutral position.
Pull both control levers slowly and evenly back-
wards; max. to half-max. reverse speed.
Move only the left control lever forwards slowly.
To stop the turn and be able to continue forwards,
move the right control lever forwards slowly until it
is in the same position as the right control lever.
To turn in an anti-clockwise direction, reverse the
procedure for a right turn.
To stop the device, bring both control levers into
the neutral position [N].
EN
19