Cub Cadet Commercial 53RWEHRF603 Instrucciones De Funcionamiento Originales página 24

EN
After 5 operating hours
refer to the engine manual).
Use the quick oil drain (optional) to drain the
oil .
Note
When draining the oil, use a suitable collec-
tion container.
After 10 operating hours
Clean the battery poles and terminals.
Every 25 operating hours
Lubricate the wheel bearings and axles of the
front wheels / cutter wheels via the grease nipples
with grease type 251H EP
Lubricate all blade shafts, tensioning pulleys and
tensioning pulley holders via the grease nipples
using grease type 251H EP.
Note
Arrange for this work to be carried out by a
service centre.
Have the dirt and grass residue beneath the V-belt
cover of the cutter deck removed by a service
centre.
Note
When mowing long and dry grass, clean the
mower at short intervals.
Every 50 operating hours
Dirt and grass remnants must be removed from
the drive gear by a service
Have drive V-belts, blade shafts and tensioning
pulleys checked for wear and damage by a ser-
vice centre.
is not located directly on the engine, but on
the frame of the device to the right of the
engine.
centre in accordance with the maintenance
intervals (see engine manual).
24
.
centre.
If required
Charge the battery:
If you are not using the battery for lengthy periods,
remove the battery from the device.
Charge up the battery every 6–8 weeks, as well
as before putting back into operation after storage.
Check the battery's charged state with a voltmeter.
When the charged state is less than 12.6 V (DC)
recharge the battery (max. 12 V at 6 A) with a bat-
tery charger in accordance with the table.
Voltmeter read- Battery charg-
ing ing state
12.7 V 100 %
12.4 V
12.2 V
12.0 V
Note
Follow the instructions in the operating
manual for your battery charger.
Replace fuses:
Replace defective fuses only with ones of an
equal rating.
Hydraulic expansion vessel
Is used as an expansion vessel for the hydraulic
only by a service centre during annual maintenance.
Note
Only perform the inspection when the hy-
draulic oil has cooled down fully.
The oil level should be at least between the
bottom of the container and the marking [1] .
Once a season
Lubricate all rotating and bearing points (operating
lever, height adjustment of the cutter deck, etc.)
with several drops of light oil.
Clean the spark plugs and set the electrode gap
or replace the spark plug (see engine manual).
The rear axles must be lubricated with a special-
purpose, water-repellent grease by a service
centre.
Have the cutter deck repaired only by a service
centre.
Note
Regularly check (during service centre visits)
the condition of the cutter deck V-belt.
Servicing
Required charg-
ing time
-
75 % approx. 90 min.
50% approx. 180 min.
25% approx. 280 min.
769-12264