Bosch GLM400CL Instrucciones De Funcionamiento Y Seguridad página 12

When cleaning a tool be careful not to disassemble any
portion of the tool since internal wires may be misplaced
or pinched or may be improperly mounted. Certain cleaning
agents such as gasoline, carbon tetrachloride, ammonia, etc.
may damage plastic parts.
The following label is on your laser tool for your safety. AL-
WAYS BE AWARE of its location when using the tool.
Notice No. 50, dated June 24, 2007 . This can lead to persons
being blinded.
DO NOT place the measuring tool in a position that may
cause anyone to stare into the laser beam intentionally or
unintentionally. Serious eye injury could result.
Never aim the beam at a workpiece with a reflective surface.
Bright shiny reflective sheet steel or similar reflective
surfaces are not recommended for laser use. Reflective
surfaces could direct the beam back towards the operator.
DO NOT operate the measuring tool around children or
allow children to operate the measuring tool. Serious eye
injury could result.
ALWAYS: Make sure that any bystanders in the vicinity of
use are made aware of the dangers of looking directly into
the measuring tool.
Do not use the measuring tool to photograph any people or
animals, as this involves the laser beam being continuously
switched on. You could blind somebody or cause accidents or
eye damage with the laser beam switched on.
12
2610050173 04-18 GLM400CL.indd 12
Safety Rules for Laser Tools
DO NOT direct the laser beam at persons or
animals and do not stare into the laser beam
yourself. This tool produces class 2 laser radia-
tion and complies with 21 CFR 1040.10 and
1040.11 except for deviations pursuant to Laser
4/19/18 11:11 AM