Initial Start-Up - Bosch GLM400CL Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

- Use only the chargers listed in the technical data. Only
these battery chargers are matched to the lithium-ion battery
of your measuring tool.
- The use of chargers from other manufacturers can lead
to defects on the measuring tool; a higher voltage (e.g.
12 V) from a vehicle charger is not suitable for charging
this measuring tool. The warranty is rendered void if
these instructions are not followed.
- Observe the mains voltage! The voltage of the power
source must correspond with the data on the type plate of
the battery charger.
Note: The battery is supplied partially charged. To ensure full
battery capacity, completely charge the battery before using
for the first time.
Note: The micro USB port 16 for connecting the micro USB
cable 22 is located under the cover of the measuring pin 8.
Press the release button 7 to open the cover.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery. When the bottom segment
of the battery charge-control indicator g flashes, only a few
more measurements can be carried out. Charge the battery.
If the frame around the segments of the battery charge
indicator g flashes, no more measurements are possible.
The measuring tool can only be used for a short time (e.g.
to check entries in the measured value list). Charge the
battery. Connect the measuring tool to the charger 23 using
the micro USB cable 22 provided. Plug the charger 23 into
the socket. The charging process begins. The battery charge-
control indicator g indicates the charging progress. During the
charging procedure, the segments flash one after the other.
When all segments of battery charge-control indicator g are
displayed, the battery is completely charged.
Disconnect the battery charger from the mains supply when
not using it for longer periods. The battery can also be charged
at a USB port. To do so, connect the measuring tool to a USB
port using the micro USB cable.
2610050173 04-18 GLM400CL.indd 21

Initial Start-Up

21
4/19/18 11:11 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido