Fitting The Sanding Disc; Selecting A Sandpaper Disc; Fitting The Sandpaper Disc - Parkside PDEXS 150 C2 Instrucciones De Uso

Fitting the sanding disc

The compressed air-powered random orbital sander
is equipped with a protective cuff
■ Rotation direction indicator of the
sanding disc
♦ To fit or replace the sanding disc
protective cuff (see Fig. 1).
Fig. 1
► Never operate the compressed air-powered
random orbital sander without the protective
cuff .
► Never operate the compressed air-powered
random orbital sander with an inverted protec-
tive cuff .
► A damaged protective cuff
replaced immediately.
♦ Turn the spindle lock
towards the flat side of the eccentric spindle
(see Fig. 2).
Fig. 2
♦ Remove the protective cap from the threaded
rod of the sanding disc
wise into the eccentric spindle
stop.
♦ Undo the spindle lock
spindle can turn freely on its own axis.
PDEXS 150 C2
All manuals and user guides at all-guides.com
.
invert the
should be
with the knurled bulge
and screw it clock-
as far as the
so that the eccentric
► Never operate the compressed air-powered
random orbital sander with a locked drive spin-
dle. This is dangerous and can result in serious
injuries.
♦ Evert the protective cuff
♦ Fig. 3

Selecting a sandpaper disc

Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper.
■ Please note that you can use sandpapers with
various grain sizes for working the different
materials.

Fitting the sandpaper disc

► Ensure that the appliance is disconnected
from the compressed air source before you
fit or remove a sandpaper disc
♦ The sanding disc and the supplied sandpaper
discs are equipped with matching Velcro
fasteners.
♦ Select the sandpaper disc
grain and press it onto the sanding disc
Ensure that it is centred.
♦ To change the sandpaper disc
side and pull it off the sanding disc
Clean the sanding disc
compressed air.
again (see Fig. 3).
.
with the desired
.
, lift it from the
.
as required with
│
US - EN 7 ■