The Setup Menu Item; Standby; Wlan Access Point - Fronius Primo 208-240 Serie Manual De Instrucciones

The Setup menu item

Standby

Manual activation/deactivation of the standby mode
-
-
-
-
-
-
-
Setting the standby mode (manual shutoff for feeding energy into the grid):
1
2
The display alternates between 'STANDBY' and 'ENTER.'
The Standby mode is now activated.
The Startup LED lights up orange.
Restoring the grid power feed operation:
In Standby mode, the display alternates between 'STANDBY' and 'ENTER'.
1
The 'Standby' entry is displayed.
The inverter also switches to the Startup phase.
After the grid power feed operation is restored, the Operation Status LED lights
up green.
WLAN Access To activate/deactivate the WLAN Access Point. For example, this is required to
Point set up or adjust the system monitoring using the Datamanager web interface. If
no Datamanager is detected by the inverter, [not available] is displayed
Setting range
No energy is fed into the grid.
The Startup LED lights up orange.
The display switches between STANDBY/ENTER
In standby mode, no other menu item can be accessed or set in the menu
level.
The automatic switching to the 'NOW' menu item after 2 minutes if no key is
pressed is not activated.
The standby mode can only be deactivated manually by pressing the 'Enter'
key.
The grid power feed operation can be resumed at any time by pressing the
'Enter' key, if no error (state code) is displayed
Select the 'Standby' entry
Press the 'Enter' function key
Press the 'Enter' function key

WLAN Access Point

[stopped]
Activate WLAN AP?
To activate the WLAN Access Point
key
WLAN Access Point
[active]
The SS-ID (SS) and the password (PW) are displayed.
Deactiv. WLAN AP?
To deactivate the WLAN Access Point
Enter key
to restore the grid power feed operation
Press the Enter
Press the
25