Datcom; Usb - Fronius Primo 208-240 Serie Manual De Instrucciones

DATCOM

Check the data communication, entry of the inverter number, protocol settings
Setting range
Status
Displays data communication available via Fronius Solar Net or an error that
occurred in data communication
Inverter Number
Number setting (address) of the inverter in a setup with multiple inverters
Setting range
Factory setting
IMPORTANT! Each inverter must be assigned its own address when using mul-
tiple inverters in a data communications system.
Protocol Type
Defines the communication protocol used to transmit data:
Setting range
Factory setting
* The interface protocol type only functions without a Fronius Datamanager
card. Existing Fronius Datamanager cards must be removed from the inverter.

USB

Value settings when using a USB stick
Setting range
IMPORTANT! The time must be set correctly in order for the logging function to
work properly.
Safely remove hardware
To remove a USB stick from the USB A socket on the data communication rack
without losing data.
The USB stick can be removed:
-
-
Software update
For updating inverter software using a USB stick.
26
WLAN Access Point
[not available]
Is displayed if no system monitoring is available on the
inverter.
Status/inverter number/protocol type
00 - 99 (00 = inverter address 100)
01
Fronius Solar Net / Interface *
Fronius Solar Net
Safely remove hardware / software update / logging in-
terval
when OK is displayed
when the "Data Transfer" LED is no longer flashing or illuminated